Posted by -3db on July 12, 2003 at 19:10:15

I am about to cut wood, and I am a little stuck with PiAlign.
I assume I have to use a pre-set speaker name, and the associated file in order to run PiAlign. Is this right. I've taken the T/S from Madison's site for the Knight 10", and this is what I get:
Qts=.578
Qes=.599
BL=13.89
Re=10.4
Xmax =4mm
eff=95db/1w
200w
I'm not sure if this is all, but the reflex box comes out at 366L, 36hz
So, I'm xover at 90 hz to subs, so I think I am going to take the 260L aperiodic options.
'does any of this sound correct.
Thanks for your help to a newbie.
Sincerely,
-3db
too big

• Re: Madison Knight 10" - Can you post a link to T/S parameters <nt>? - wunhuanglo 11:02:43 07/13/03 (0)
• Re: a little help - Bill Martinelli 20:34:16 07/12/03 (1)
  • Thanks Bill: I will try these numbers before cutting. nt - -3db 23:37:25 07/12/03 (0)