Posted by AstroSonic on May 08, 2003 at 11:09:16

In Reply to: more on fin cutting posted by tdc on May 07, 2003 at 17:35:30:

TDC,

I am pretty much convinced that fin cutting will be a part of my 511B ringing control plan. Sam P. (below) also did this and reported good results. He used a sawzall and needed to make several cuts per fin to remove enough material. How did you cut them and what tool(s) did you use? Any hind-site observations greatly appreciated.

Good idea using the radial tire matrerial (to damp radial horns!). In as much as I do play some blues and rock on my system, perhaps I should use material from off-road radials.

Regards,

AstroSonic

• Re: more on fin cutting - tdc 11:27:04 05/08/03 (5)
  • Fin cutting - Just the welds! - AstroSonic 12:12:58 05/08/03 (4)
    • Re: Fin cutting - Just the welds! - tdc 13:38:29 05/08/03 (3)
      • Depleted uranium and radial tire rubber - Wayne Parham 14:02:57 05/08/03 (2)
        • Re: Depleted uranium and radial tire rubber - tdc 14:36:36 05/08/03 (1)
          • Re: Depleted uranium and radial tire rubber - Wayne Parham 14:50:04 05/08/03 (0)