Posted by AJ [ 210.48.81.117 ] on March 28, 2004 at 16:15:54:

Hi, I want to find out where the factory design axis for the MF and HF horns is of the Yorkville TX8 cab.
Has any one taken 1m on axis measurents of these cabs using the
company's TX8P processor?
One would think the design axis would be between the horns,
but the reverse phase null measurements I'm getting here don't show a that point.When measuring at distance of 1M ,the reverse phase null is actually above the centre axis of the hf horn.Is this correct?
Cheers.

Replies: