Anyone here with a working ARTA impedance measurement box ?

[ Measurement Forum ] [ Help ]

Posted by zobsky [ 199.171.212.100 ] on July 02, 2007 at 14:40:13:

I'd like to verify resistances between various points of the jig to verify if my ARTA impedance jig is wired correctly.

Even better if you are in the Dallas area.

I can generate the correct response curves (shapewise, impedance peak at correct frequency)but the impedance values themselves are off, despite the correct reference resistor and calibration procedure.

Thanks


Replies:



[ Measurement Forum ] [ Help ]