Re: A heretical tip from a heretic.

[ HighEfficiencySpeakers Forum ] [ Help ]

Posted by Adrian Mack [ 202.137.102.235 ] on April 09, 2004 at 08:35:52:

In Reply to: A heretical tip from a heretic. posted by Bill Fitzmaurice on April 09, 2004 at 07:02:26:

Hmmm, I was thinking about the same thing. Ive heard some say they couldn't even get measured differences with and without reflectors.

I was thinking, maybe I should remove all reflectors but the bottom two? Because they keep the areas right for expo flare as in:

I think I'd rather just have them all out though, but it makes the bit in the middle a lot bigger area than surrounding bits:

But I dunno if it matters. Technically it should make my path length a bit longer I think if I remove the reflectors, so thats good (stays flat and just goes even lower according to Hornresp, all good!).

So should I forget about all the reflectors and leave them out? If you say it'll be fine I believe ya. Hornresp doesn't seem to show much change anyway with a fatter 3rd segment... It will be so much less effort to build.

Adrian


Replies:



[ HighEfficiencySpeakers Forum ] [ Help ]