Posted by Wayne Parham [ 65.214.102.163 ] on February 19, 2007 at 10:53:28:

In Reply to: Re: Compresison ratio and front chamber size posted by Ian on February 19, 2007 at 01:11:33:

I've modeled a few horns with throat area equal to diaphragm surface area and measurements from physical models corresponded quite well. The only places where the computer model didn't reflect the physical model were where I expected them not to match because of breakup modes or directivity from radiator diameter collapsing further than flare angle.

• Breakup modes and collapsing directivity

Replies:

• Re: Compresison ratio and front chamber size - Cuppa Joe 23:38:22 02/21/07 (8)
  • Re: I was considering a B&C 8PE21 - swett 21:37:28 02/22/07 (3)
    • Re: I was considering a B&C 8PE21 - Cuppa Joe 23:03:32 02/22/07 (2)
      • Re: I was considering a B&C 8PE21 - Wayne Parham 01:15:09 03/01/07 (1)
        • Re: I was considering a B&C 8PE21 - Cuppa Joe 21:14:58 03/01/07 (0)
  • Re: Compresison ratio and front chamber size - Wayne Parham 11:28:26 02/22/07 (3)
    • Re: Compresison ratio and front chamber size - Cuppa Joe 22:50:52 02/22/07 (2)
      • Straight side walls - Wayne Parham 12:12:36 02/23/07 (1)
        • Re: Straight side walls - Cuppa Joe 22:08:03 02/23/07 (0)