Posted by Peter K [ 130.225.37.97 ] on March 29, 2006 at 00:56:55:

Hi,

I would like to make L-pads for my BMS 4592 ND drivers. However, I am not quite sure whether to base the calculation on the drivers "nominal impedance" (which is 16 Ohm) or their Re values, which according to the people at BMS are 8.9 Ohm for the "mid" section and 7 Ohm for the "tweeter" section.

I have actually heard both claims stated!? Could some of you tech-guys (Wayne P.?) please tell me which route is correct? Thanks!

Regards
Peter

Replies:

• Re: Is calculations of L-pads based on "nominal impedance" or Re? - Wayne Parham 09:43:04 03/29/06 (5)
  • Re: Is calculations of L-pads based on "nominal impedance" or Re? - Peter K 11:05:01 03/29/06 (4)
    • Re: Is calculations of L-pads based on "nominal impedance" or Re? - Wayne Parham 11:41:05 03/29/06 (3)
      • Re: Is calculations of L-pads based on "nominal impedance" or Re? - Peter K 12:38:46 03/29/06 (2)
        • Re: Is calculations of L-pads based on "nominal impedance" or Re? - Wayne Parham 13:10:15 03/29/06 (1)
          • Re: Is calculations of L-pads based on "nominal impedance" or Re? - Peter K 13:29:01 03/29/06 (0)