Posted by manualblock [ 69.112.69.86 ] on March 05, 2005 at 19:40:02:

In Reply to: the Amp posted by Tnuctipun on March 05, 2005 at 18:54:30:

Sounds good to me.
Now I just need a little TLC.
On the filament trans I ran one wire from the secondary to each lug on a strip then connected a diode on each lug to the secondary wires. from there I tookthe opposite end of both diodesd and soldered them to one end of a two ohm resistor. I then took the other end of the resistor and soldered it to the pos. end of the first filter cap, with the other end of the filter cap to ground. I also grounded the CT of the RS trans.secondary.
Then I took one end of the second 2 ohm resistor and tied that to the pos end of the second filter cap and ran the neg end of the cap to ground. I then took the tab with the res/cap pos end and ran a wire to pin 4 of the 5687. I then ran a wire from pin 5 to ground. Is this correct?

Replies:

• Re: the Amp - Tnuctipun 19:54:51 03/05/05 (8)
  • PCB for CCS - colinhester 20:50:51 03/05/05 (7)
    • Re: PCB for CCS - Wayne Parham 00:15:07 03/06/05 (0)
    • Re: PCB for CCS - Tnuctipun 21:37:39 03/05/05 (5)
      • Re: PCB for CCS - manualblock 06:46:21 03/06/05 (4)
        • T-220 mounting sockets - colinhester 07:16:27 03/06/05 (3)
          • Re: T-220 mounting sockets - manualblock 08:29:17 03/06/05 (2)
            • No minimum but a service charge - colinhester 09:55:14 03/06/05 (1)
              • Re: No minimum but a service charge - manualblock 10:05:12 03/06/05 (0)