Re: Hey Colin, get out that fancy router and table saw

[ GroupBuild Forum ] [ Help ]

Posted by bill epstein [ 65.189.211.118 ] on April 26, 2007 at 21:09:42:

In Reply to: Re: Butt-joint veneer posted by colinhester on April 11, 2007 at 14:02:23:

Rout off the corners of the cabinet creating a 1/2" wide rabbet on the front and adjacent side. Glue in a strip of hardwood and leave it 1/4" proud of the substrate + veneer. The proud edge of the hardwood after you veneer looks like you did it on purpose and the shadow line it creates is a nice detail.

No seam needed.

Your Uncle Bill


Replies:



[ GroupBuild Forum ] [ Help ]