Re: vanes here!

[ GroupBuild Forum ] [ Help ]

Posted by bill epstein [ 65.189.211.118 ] on September 23, 2006 at 12:50:09:

In Reply to: Re: vanes here! posted by SteveBrown on September 23, 2006 at 10:31:44:

Find a spoke shave at a flea market. Tune and sharpen it.

Cut the flare with a jigsaw or bowsaw and Plane the curve to the line with the spokeshave.

Or 3M #77 spray glue 60 grit paper on an 1 1/4" dowel. Shouldn't take much longer than the spokeshave. But it's such a satisfying tool to use.

I mostly use my Record convex one to smooth out speaker cut-outs after I've managed to have that freakin' dimple cut-out when the hole jig slips as the cut-out is completed.



Replies:



[ GroupBuild Forum ] [ Help ]