Re: Ah there we go

[ GroupBuild Forum ] [ Help ]

Posted by 2wo [ 70.110.247.94 ] on September 17, 2006 at 22:06:23:

In Reply to: Re: Ah there we go posted by manualblock on September 14, 2006 at 10:36:30:

This is actually a broiler pan. I needed the much heavier steel, to support the unusually large iron load, 18# for the PS trans alone.

The down side is they are harder to work. I am still using a hole saw to cut the tube sockets. A 1 1/8" will go through a cakepan like cheese. With the broiler pan, I needed cutting oil and time.

The upside, they are 3" deep and damn near bullet proof…John



Replies:



[ GroupBuild Forum ] [ Help ]