Re: SE 300B Project, Part 13 - The finished amp

[ GroupBuild Forum ] [ Help ]

Posted by horny [ 84.28.64.63 ] on August 16, 2006 at 15:43:40:

In Reply to: Re: SE 300B Project, Part 13 - The finished amp posted by Damir on August 13, 2006 at 17:00:50:

hello Damir
I tryed the led and i like it more then a resistor and 220uf Nichicon Muse capacitor
The thin sound that i write was because the tubes are new
later the sound become fuller and fuller and to full
then the amp was a little to dark the led brings it a little on the back right way the sound get also very very clean i like it but other builder maby find it to clean

i had 3 to 3,2 volt cathode bias with the 280 ohm resistor and 190v on the anode (c3g)
with the red leds i have 3.65 and 210 volt on the anode
have i used the wrong leds?
can i leave it this way or must i chance it?
regards Robert


Replies:



[ GroupBuild Forum ] [ Help ]