Posted by 2wo [ 71.242.5.40 ] on May 30, 2006 at 23:07:08:

In Reply to: Re: A few measurements posted by Damir on May 30, 2006 at 08:16:05:

What, read the x1 scale, rather than the x10 scale? I would never admit to a dumb mistake like that.
Well, OK. More like 20V p-p or 7-8V rms, for more like about 4 watts.

The test setup, such as it was… Readings taken from the transformer output ( a Lundahl 1623, Connected as 5.6k -16 ohms). Into a 16 ohm non inductive dummy load.

I use this setup so I can connect to friends, 8 ohm speakers.

So, after you so kindly pointed out the gross errors. I see that I need a bit more voltage swing on the driver. I will work on raising Va next.

Thanks for your dB refresher course, I guess it’s "use it or lose it" …. Or what was the question again ? ...John

Replies:

• About 50W with 4xEL34 in UL... :-) - Damir 06:41:09 05/31/06 (2)
  • Re: About 50W with 4xEL34 in UL... :-) - 2wo 21:40:33 06/04/06 (1)
    • That`s right, folks... - Damir 08:46:25 06/05/06 (0)