Bleeder Resistors

[ General Forum ] [ Help ]

Posted by Shane [ 66.143.195.210 ] on October 16, 2006 at 23:34:11:

I know this has been covered about 1000 times (maybe more)and I posted this over on the Bottlehead site as well, but just wanting to see if using these particular clips with a bleeder resistor would be the way to go to discharge caps? Just solder in the resistor after cutting the lead wire and heatshrinking everything 2-3 times over the resistor leads and edge of the resistor? Oh, and don't touch the resistor or let it touch other things, I'm thinking, as the cap discharges.



Replies:



[ General Forum ] [ Help ]