I'm open

[ General Forum ] [ Help ]

Posted by colinhester [ 65.27.134.38 ] on September 14, 2006 at 12:30:19:

In Reply to: Re: How To Implement The Smithy posted by GarMan on September 14, 2006 at 11:49:59:

...to any ideas. I have a pair of A7 cabs that I'll use for the bottom-end, but other than that I don't care. However, all of us need to be on the same page for the HF compression drive size. This will make the CNC parts a little more cost effective......Colin


Replies:



[ General Forum ] [ Help ]