Re:try grizzly

[ Craftsmen Forum ] [ Help ]

Posted by GarMan [ 216.13.136.38 ] on April 21, 2005 at 15:51:05:

In Reply to: Re:try grizzly posted by Bill Martinelli on April 21, 2005 at 15:03:03:

You say cutter. I say bits. Must be a regional thing.

I've bought Onsrud spiral up-cuts from Lee Valley and they are very good. Went through 3/4" MDF like butter in just two pass. Could have even done it in one, but didn't try.

I'll look up Bosch and Grizzly next time I need a new "cutter" (see, I can adapt!). Since I've got my portable router table setup, I'm looking at cutters that I've never considered before.

thx,
Gar.


Replies:



[ Craftsmen Forum ] [ Help ]