I learned some things Re: Mine works fine

[ Craftsmen Forum ] [ Help ]

Posted by lon [ 209.103.193.197 ] on August 03, 2004 at 16:05:09:

In Reply to: Mine works fine posted by Bill Fitzmaurice on August 02, 2004 at 14:59:09:



I think Mr. Epstein also had some help with the
routing stuff so here is my update on what I learned.


First I sharpened my bets on a simple kitchen knife
diamond stone... it is getting pretty worn down anyway.


Then I did incremental cuts which improveds things
immensely.


The peduliar thing I noticed was that the cut would
consistently be uneven-- one side higher than another.
It must have been my technique so I just worked
from the opposite side of the piece so the pressure
was evened out.


Result: a smooth even cut which I was able to edge
sand to get the tear-out smoothed.


No smoke this time. ;-)


lon@athenet.net




Replies:



[ Craftsmen Forum ] [ Help ]