Cutting a cut-out in 40mm maple - Done!

[ Craftsmen Forum ] [ Help ]

Posted by Brian C. [ 62.255.64.6 ] on July 07, 2004 at 13:30:43:

In Reply to: Cutting a cut-out in 40mm maple posted by Brian C. on June 29, 2004 at 04:16:38:

After marking out I drilled a few 10mm holes at strategic points and cut the thing easy-pleasy with my humble B&D jigsaw. No broken blade, no burnt-out motor. Phew, what a relief!

Now I need 3 temporary supports until my roller bearings show up...
I'll try an put a photo up when everything is finished.

Brian.


Replies:



[ Craftsmen Forum ] [ Help ]