Thanks to both Bills!

[ Craftsmen Forum ] [ Help ]

Posted by Brian C. [ 62.255.64.6 ] on June 30, 2004 at 11:20:03:

In Reply to: Cutting a cut-out in 40mm maple posted by Brian C. on June 29, 2004 at 04:16:38:

I'm taking a leaf out of the book of a friend who has just sunk a sink unit and a cooker hob into a worksurface - I'm going to start off with a hole-saw bit in my power drill, then will come the jigsaw (just purchased some more blades!) and finally finish with the router.

The template is a copy of the original Garrard print on a large sheet of paper. The dimensions are slightly out but it does state what the measurements between centres should be for the mounting holes so I should be able to get it down accurately.

I'm afraid over here in the UK it is not easy to find a helpful pro shop these days :o(

In the fullness of time a picture will appear....

Brian.


Replies:



[ Craftsmen Forum ] [ Help ]