Posted by lon [ 209.103.193.88 ] on June 15, 2004 at 00:53:30:
I am just back form a discussion at rec.woodworking about
how to use a spin saw and it's attachments.
They initially dissed me for getting one of these things.
I explained I don't have a shop and the fact that a spin saw
(Rotozip type) sends the waste down rather than into air.
I also referred to the project which is down below in
in this forum called "most excellent project from Canada".
Was wondering as to what the opinions might be from the
readers here directly on the topic of spin saws:
Who uses them who does not and why?
The photos from the 'most excellent' project show
ar fream/page 3 that the guy is using a standard 1/4
shank roundover bit. I'm hoping to do the same as well
as some small chamfer and rabbet techniques.
In the case that someone offers some extreme drawback,
I have not used the device yet. It is still in the box.
I can take it back and say that some stupid person got it
for me for Father's Day and offload the embarrassment. :-|
Oddly, I sent a mail to the guy with the most excellent
slideshow but got no reply.
lon@athenet.net
[ Craftsmen Forum ] [ Help ]