Posted by lon [ 209.103.193.249 ] on May 28, 2004 at 01:40:50:
In Reply to: Re: Porter Cable 690 and some HUEVOS! posted by Bill Martinelli on May 27, 2004 at 22:08:12:
Ok. This is slightly diffferent ( by my reading) than described
over at full range driver site. I've done the break-in routine on two
pairs of speaks. Method used was putting the speaks face to face and
bolting them together. I checked the polarity by using a
small battery and test leads and hooked up the wires push and
pull respectively. It still makes a good amount of racket.
When doing this procedure it'd be handy to have a small safe
with wire leads drilled in the back. :-)
[ Craftsmen Forum ] [ Help ]