Posted by Dean Kukral [ 66.82.9.18 ] on March 29, 2004 at 08:50:09:

In Reply to: Re: Table saw recommendations? posted by Dean Kukral on March 29, 2004 at 08:34:38:

I have looked and tried to find a reference to the thing I was describing, but I keep getting the wrong thing.

What I am describing is a piece of aluminum railing about four feet long that you clamp to the plywood and run your saw along the edge, keeping a straight line. I suppose that you could do the same with a length of wood, but then you would not get to buy a neat new tool.

I have seen these in the woodworking magazines.

Replies:

• Re: follow-up - crazychile 07:19:50 03/30/04 (11)
  • Re: follow-up - Bill Fitzmaurice 07:56:04 03/30/04 (10)
    • Re: follow-up - crazychile 10:40:51 03/31/04 (2)
      • Re: follow-up - Bill Fitzmaurice 10:56:24 03/31/04 (1)
        • Re: follow-up - crazychile 07:17:46 04/02/04 (0)
    • Re: follow-up - Dean Kukral 19:50:57 03/30/04 (6)
      • Re: follow-up - Bill Fitzmaurice 07:11:58 03/31/04 (5)
        • Wait a minute - Dean Kukral 07:49:12 03/31/04 (1)
          • Re: Wait a minute - Bill Martinelli 22:35:26 04/02/04 (0)
        • Re: follow-up - Dean Kukral 07:33:22 03/31/04 (2)
          • Re: follow-up - Bill Fitzmaurice 09:38:43 03/31/04 (1)
            • Re: More so with MDF - Bill Epstein 18:00:26 03/31/04 (0)