4 ohm wiring

[ ArraySpeakers Forum ] [ Help ]

Posted by lcholke [ 68.252.248.248 ] on July 20, 2004 at 09:05:51:

In Reply to: Re: A Few Answers posted by Jim Griffin on July 19, 2004 at 15:14:12:

Hi Jim,

I was reading this post (very helpfull) and had a question. Will changing the Qes or Qt by wiring for 4ohms change the sound. My pe-87 16 array sounded lifeless, wired for 8 ohms. 4ohms was to lively and 6ohms (12 drivers) seems just right =; ). I have them open baffle and the amp is .1 ohm published.


You wrote,
If you have to increase the sensitivity, then wire them for a lower impedance (a 4 ohms array would yield 3 dB more sensitivity or slightly more than 95 dB SPL).

-----
Linc




Replies:



[ ArraySpeakers Forum ] [ Help ]