Re: Full range drivers in line array?

[ ArraySpeakers Forum ] [ Help ]

Posted by Jim Griffin [ 12.180.247.134 ] on February 17, 2006 at 08:31:49:

In Reply to: Re: Full range drivers in line array? posted by flacoman on February 17, 2006 at 07:35:12:

Jorge,

Yes, that is the way to go in this case--use a crossover to a tweeter or a line of tweeters. I've found that simple first order crossovers (single component) aren't sharp enough for most line array implementations so a third or fourth order usually works better. Furthermore, the crossover likely will need to be when the midrange line starts to lose sensitivity. This would likely be in the 2-3.5 kHz area. Measurements help to determine specific crossover points.

Jim


Replies:



[ ArraySpeakers Forum ] [ Help ]