Posted by FredT [ 24.175.120.40 ] on November 30, 2005 at 12:22:41:

In Reply to: Re: My Advice About DIY Line Arrays posted by Tom R. on November 30, 2005 at 10:54:46:

Woofer arrays must be crossed over a fairly low frequencies because of the comb effect above the frequency where the driver starts beaming. I'll refer you to Jim Griffin's nearfield line array white paper for an explanation. See the section on center-to-center driver separation for circular drivers starting on page eleven.

• Nearfield Line Array White Paper

Replies:

• Re: Woofer Array Crossover Frequency Limitations - Tom R. 13:11:46 11/30/05 (1)
  • Array driver response - Bill Fitzmaurice 09:33:53 12/09/05 (0)