Home » Sponsored » Pi Speakers » BMS compression drivers and Pi ?
Re: BMS compression drivers and Pi ?: OOPS! [message #43828 is a reply to message #43825] Sat, 31 January 2004 19:36 Go to previous messageGo to previous message
Adrian Mack is currently offline  Adrian Mack
Messages: 568
Registered: May 2009
Illuminati (1st Degree)

> I'm sure that the Peavy horn goes low enough to cover a 16K
> crossover.

Bill was talking about the crossover point at the lower limits. What his saying is the Peavy CH3 horn doens't go below 1KHz so well and is best used a little higher than this. But the larger JBL 2370 can be used from a much lower frequency, ~800Hz.

Adrian

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: can the 2445J use in the pro 4 instead of the 2426?
Next Topic: baffle spacing, vertical alignment
Goto Forum:
  


Current Time: Sun May 19 08:42:02 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest