AudioRoundTable.com: Thermionic Emissions

Home » Audio » Thermionic Emissions » High Power Output SET

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Riiiight... [message #11027 is a reply to message #11024]

Sun, 27 February 2005 20:38

PakProtector
Messages: 935
Registered: May 2009

Illuminati (2nd Degree)

Let's see, Boeing has to tell PECO when they fire up their MW wind tunnel, I don't think you'll find many DIY running such things as that.

I have some DH Pentodes. 450W CCS anode rating. 120W g2 rating and a 10W g1. I am planning on a PP amp for ~300W output and still single-pair, Class A. No cooling fans needed. The glass is reated to 660 F.

they make an 833A look medium sized. The anode cap is 6SN7 sized. figure a PS for the PP amp to deliver 700 mA at 1k2Volts for the finals and drivers. G2 will be significantly lower, and run from its own supply.
regards,
Douglas

Report message to a moderator

[Message index]

		High Power Output SET By: wunhuanglo on Sun, 27 February 2005 11:53
		Re: High Power Output SET By: Wayne Parham on Sun, 27 February 2005 14:58
		Be a man - run PP (nt) By: colinhester on Sun, 27 February 2005 20:18
		Re: Be a man - run PP By: Wayne Parham on Sun, 27 February 2005 22:01
		Riiiight... By: PakProtector on Sun, 27 February 2005 20:38
		Re: High Power Output SET By: Steve on Sun, 15 May 2005 11:56

Previous Topic:	ASL AQ1006 845 DT SET Amp
Next Topic:	Tono Preamp

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 11 08:25:06 CDT 2024