Home » Audio » Group Build » RIAA preamp project
icon14.gif  Re: RIAA preamp project [message #67230 is a reply to message #67167] Tue, 26 April 2011 11:15 Go to previous messageGo to previous message
gofar99 is currently offline  gofar99
Messages: 1907
Registered: May 2010
Location: Southern Arizona
Illuminati (5th Degree)
Hi, A lot of thought went into the project Smile . I have been working for about 8 months or so on a RIAA preamp. I tried several variations and none have quite done what I want. I have no problem with gain, overload, Z out, frequency response. The one area I want is a S/N of over 90 dbv at 1 volt output. I can get 85 now. The best topology so far is a 12AX7 SRPP feeding a second 12AX7 SRPP followed by a E88CC cathode follower. The equalization is active between the third and first stage. The active mode gave better S/N than a passive one between the first and second stages. I sympathize with the problems you have experienced with measurements. I have a raft of test gear incl 2 DSO, a HP distortion analyzer, two signal generators and more meters than I can count. Still the process of measuring RIAA preamps is both tedious and can be misleading. When I get it a little closer to what I want, I'll post it.

Where did you get the power transformer? Small ones for this type of project are difficult to locate except through overseas sources.



Good Listening
Bruce
 
Read Message
Read Message
Read Message icon14.gif
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: IR Remote Control
Next Topic: Home-made Boomboxes
Goto Forum:
  


Current Time: Wed May 15 18:48:27 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest