| |
89 Search Results Found |
| 1 |
Forum: Pi Speakers «»
Posted on: Thu, 02 November 2023 15:36 «»
By: scwheat
3Pi plans and questions
Can you also send me the 3Pi plans? I would like to use the B&C DE250 if that makes a difference. I'd like to build 3 for LCR.
A few questions as well.
What would your recommendation for LFE crossing over to a 15-inch sub via the receiver? IE...
|
| 2 |
Forum: Pi Speakers «»
Posted on: Fri, 02 June 2023 09:57 «»
By: leimahmood
Re: Jbl 2226h and 2447h
And kindly share 4pi speaker plan and do they work well in home theater as a LCR left right ceneter listening position is aroound 17 feet max may be around 17 to 15 feet some where
|
| 3 |
Forum: Pi Speakers «»
Posted on: Sat, 25 July 2020 11:14 «»
By: rvsixer
Re: Definimax 4012HO - End of Life
I have been wanting to build either 6pi mains with 3pi center, or 3pi LCR setup, for a few years now. Have started looking for a new house again, hoping to find one with a room that supports the cornerhorns, but if not 3pi LCR it is.
Wayne's comments h...
|
| 4 |
Forum: Pi Speakers «»
Posted on: Thu, 14 February 2019 02:25 «»
By: Symphonimind
Questions about H290C horn and 3Pi Subwoofer
Dear Wayne,
I am preparing for my first 3Pi with 4012HO and DE250. I decided to flushmount 3x 3Pi (LCR) in my studio and use with 4x 3Pi subwoofers, so I want to build optimized cabinet for 4012HO. The cabinet will be all 25mm MDF with 4mm bitum layer d...
|
| 5 |
Forum: Pi Speakers «»
Posted on: Mon, 10 October 2016 15:04 «»
By: Wayne Parham
Re: 4Pi answers
I'll embed my answers, interleaved in your questions:
That's ideal. There are a lot of people here that run four π mains in all three front positions, left, right and center. See the link below for some examples. If you have an acoustically trans...
|
| 6 |
Forum: Pi Speakers «»
Posted on: Mon, 10 October 2016 09:17 «»
By: jeenyus
4Pi questions
Hi Wayne, (or anyone else more knowledgeable than myself)
First of all, thank you for the wealth of information you provide to us all... I can't begin to imagine the number of hours you've dedicated to this forum.
I plan on building 4pi's to replace ...
|
| 7 |
Forum: Pi Speakers «»
Posted on: Fri, 20 November 2015 18:41 «»
By: rvsixer
6pi Mains, 3pi Center
I have been studying the 6pi plans, and noted the tweeter/midrange are located significantly higher than the normal "tweeter near ear height" rule.
With curiosity I searched, and found a message that indicated this is intentional, something to...
|
| 8 |
Forum: Pi Speakers «»
Posted on: Sun, 18 October 2015 11:53 «»
By: Wayne Parham
Re: 4pi LCR new Project
Sounds like you will build a very fine home theater. The four π loudspeaker is perfectly suited to your purpose.
Many people build the center channel sealed. It allows the waveguide to be centered in the center speaker. Keep the right and left chan...
|
| 9 |
Forum: Pi Speakers «»
Posted on: Sat, 17 October 2015 23:10 «»
By: gavin1957
4pi LCR new Project
Hi Wayne,
I have just built a new home in Australia and included a dedicated room for my home theatre and would like to use the 4pi design for the LCR built into a baffle wall with a 120" 2.35:1 Seymour AT screen. do you see any issues using the 4p...
|
| 10 |
Forum: Pi Speakers «»
Posted on: Tue, 09 September 2014 16:21 «»
By: Wayne Parham
Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR?
Push that lowest mode up above 300Hz. The lower mids are where we start losing damping from the insulation, so raise that up a bit. You can also use a sheet of insualtion spanning the cross-section to increase its damping ability in the lower midrange ...
|
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
