I am new to the business. And need some helps from all you seniors: I bought JBL 2402H, 2447J and E-155H for 4-pi 18 bass reflex series. But I can not run Wayne's DOS progrm on my SUN workstation to get the proper box volume and port size/length. Any one can help me run the number, please? I am planning to active cross around 1kHz for 2447J and E-155H.
Thanks a lot!
Here is the spec for E-155H: fs 30, qts 0.2, qms 2.2, qes 0.22, vas 424.8 lites, eff 4.9, pe 300w, Xmax 5.08mm, re 6 ohm, le 1.4 mH, sd 0.114 m*m, bl 25 N/A, m 125 g
Wayne Parham Messages: 18698 Registered: January 2001
Illuminati (33rd Degree)
PiAlign recommends a 3.0ft3 cabinet tuned to 56Hz using a port that's 5.25" x 9.375" and 7.25" long. Performance is very good using this cabinet. I wouldn't recommend tuning at 30Hz unless the cabinet were made much larger - around 8ft3 - in which case you will have generated an EBS alignment. Trouble is that this will reduce output below 100Hz -6dB.
The PiAligned 3ft3 56Hz cabinet provides flat response with f3 of 60Hz. The 8ft3 30Hz EBS alignment is -6dB down below 100Hz, but stays at this level down to 30Hz and the shelf is flat. Both are pretty good solutions, depending on your application.
Is that mean 2226J will out-perform E-155h around 40Hz? If so, I will go for 2226J instead of E-155h. The reason I bought E-155h is that it is 18" with lower fs(30Hz vs. 40Hz of 2226J).
Wayne Parham Messages: 18698 Registered: January 2001
Illuminati (33rd Degree)
These drivers are really tuned for high-output output above 40Hz. They can be used below this frequency, but they aren't designed with specs that make them well-suited for operation in the 20Hz - 40Hz octave. Looks for drivers with more moving mass and a little bit higher Q.
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
